Page Comparison

Points to know when installing the no calibration RTLS.  (Provisioning videos)

1. 1. Ensure all BluFi are placed with minimal obstructed view, recommendation is placing at 4 feet or higher above the floor.
   2. Ensure no metal is directly in-front of BluFis. – Tables, chairs, cabinets, etc, that are within 6 feet or less from the BluFi is not recommended.
   3. For good Trilateration, beacon should be seen by at minimum of 6 BluFis. Meaning there's that many BluFi within a 20~25 Meter Radius from where you are tracking.
   4. IMPORTANT: Make sure BluiFis are on Multi-Channel mode, and every beacon is using Asset Tracking template.
   5. Do note: some oscillation of beacon position is normal for non-calibration RTLS. For more accurate and faster latency, calibration is preferred. To improve oscillation in non-calibration RTLS, see point f below.
   6. Some improvement of oscillation may be improved by selecting the settings tab and changing the Bucket, Overlap & Period each to 3000 ms or more. This will add latency of approximate 5 seconds or more to the results, but it will smooth the oscillation of the location. Increasing it to 4000 or 5000 will smooth even further. 
      
      
      Please see image below:

...