Page Comparison

Points to know when installing the no calibration No-Calibration RTLS.  (Provisioning videos)

1. 1. Ensure all BluFi are placed with Place the BluFis in such a way as to ensure there is minimal obstructed view, . Our recommendation is placing at 4 to place the BluFis at four feet or higher, above the floor.
   2. Ensure there is no metal is directly in-front of BluFis. the BluFi – Tables, chairs, cabinets, etc, that are within 6 six feet or less from the BluFi is not recommended.
   3. For good Trilaterationtrilateration, the beacon should be 'seen by at ' a minimum of 6 six BluFis. Meaning there 's that many BluFi are six BluFis within a 20~25 Meter Radius from meter radius of where you are tracking.
   4. IMPORTANT: Make sure BluiFis BluFis are on 'Multi-Channel' mode, and every beacon is using 'Asset Tracking' template.
   5. Do noteNote: some Some oscillation of beacon position is normal for non-calibration RTLS. For more accurate and faster latency, calibration is preferred. To improve oscillation in non-calibration RTLS, see point 'f' below.
   6. Some improvement of oscillation may be improved Beacon position oscillation can be reduced by selecting the settings tab and changing the 'Bucket', 'Overlap' & 'Period' each to 3000 ms or more. This will add latency of approximate approximately 5 seconds or more to the results, but it will smooth the oscillation of the location. Increasing it to 4000 or 5000 ms will smooth stabilize the oscillation even further. 
      
      
      Please see image below:

...